Configuration: Network Management - HP StorageWorks MSL2024 User's And Service Manual
Tape libraries
Hide thumbs
Also See for StorageWorks MSL2024:
- Quickspecs (26 pages) ,
- Getting started (13 pages) ,
- Product brief (4 pages)
Table of Contents
Advertisement
•
DHCP Address — when On, the Library will request an IP address from a DHCP server each time
the device is booted. The default is On.
•
Static Address — configures the IP address if DHCP is not enabled.
•
Subnet Mask — configures the network mask of the library controller if DHCP Address is not On.
•
Gateway Address — configures the gateway address if DHCP Address is not On.
•
IPv4 DNS Server 1 and IPv4 DNS Server 2 — configures the addresses of up to two DNS servers
if DHCP Address is not On.
For IPv6, you may change the:
•
IPv6 DNS Server 1 and IPv6 DNS Server 2 — configures the addresses of up to two DNS servers
if DHCPv6 is not enabled.
•
Stateless Addressing Enabled — when On, the Library will generate an address for itself based
on the routing information obtained from a router advertisement and the MAC address. The Library
can manage up to five global addresses at the same time, which can be assigned from different
routers. The default is On.
•
DHCPv6 Addressing Enabled — when On, the Library will request an IP address from a DHCP
server each time the device is booted. The default is Off.
•
Static Addressing Enabled — when On, the Library will use a statically-configured address. The
default is Off.
•
Static Assigned Address — configures the address when Static Addressing Enabled is On. You
can select the standard prefix, FE80:, or the prefix of a nearby router. Enter the remainder of the
address and click Add.
To remove an IPv6 static IP address, click Delete next to the address in the Current IPv6 Addresses
pane.
Configuration: Network Management
Use the
Configuration: Network Management page
Management Protocol), which allows applications such as HP Systems Insight Manager
www.hp.com/products/SystemInsightManager) to manage the device. The device supports both
SNMP configuration and SNMP traps. SNMP can only be configured with the RMI; it cannot be
configured with the OCP.
Command View TL TapeAssure provides comprehensive summaries and detailed information about
the properties, performance, utilization, and health of all tape drives and media for all monitored HP
libraries. This data can be exported on demand or at scheduled times to a comma-separated values
(.csv) file for analysis with spreadsheet programs or custom scripts.
90
Operating the Tape Library
to enable and configure SNMP (Simple Network
(http://
Advertisement
Table of Contents
