Table of Contents
Advertisement
Installing the DLT80 Tape Drive
Note:
included with your server.
To install a DLT80 tape drive with drive rails:
1. Adhere the front labels as described in "Preparing the Tape Drive."
2. Install the tape drive into two adjacent available media bays.
Figure 7: Installing a DLT80 drive with drive rails
3. Insert two screws in the front plate using a Torx T-15 screwdriver.
4. Connect an available power cable and the wide SCSI signal cable.
DLT80 Tape Drive Reference Guide
Your server may differ from the following illustrations; refer to the documentation
Installing an Internal DLT80 Tape Drive
C T
SE LE
T
EJ EC
R
EN TE
25
Advertisement
Table of Contents
