Table of Contents
Advertisement
5.4 Measure Set-up Menu 2 (Setup of Combination)
How to set up combination. (When the cyclic control with combination is not used
is required.)
Combination setting is used to increase the number of controllable capacitor circuits by using two units
of this device with the cyclic control. For details
Measure Set-up Menu END is displayed by pressing
simultaneously in Operation Mode.
,
Furthermore
Measure Set-up Menu
,
Then
the following set-ups are possible.
＋ −
Measure Set-up Menu
ENTER
DISPLAY
＋ −
CombinationON/OFF
ENTER
DISPLAY
＋ −
Master/Slave
ENTER
＋ −
Measure Set-up Menu
・
NOTE
・
,
refer to page
2
is selected by pressing
2
Choose
from Measure Set-up Menu .
(screen on the right is displayed)
Key
Set up Combination ON/OFF .
oFF (Single Operation)
Key
on (Cyclic control operation
with combination)
Set up Master/Slave .
Master
Key
Slave
Note 1. When "OFF" is selected in "Combination ON/OFF" , skip this set-up.
Choose whether to complete the set-up refer
22
23
to page
and
set-up or to continue other set-up.
Key
When Combination ON/OFF set-up is ON
cyclic control.
When this Set-up is changed
control starts again.
48
.
Key and
ENTER
＋
Key or
about how to finish the
,
control method serves as only
,
all the connecting capacitors are cut off and the
29
,
no this setting change
2
Key for
seconds
CAPACITY
−
Key.
* The present setting value is displayed.
"Slave" sign flickers, when
you choose "Slave".
* A changed setting value is displayed.
Advertisement
Table of Contents
