Table of Contents
Advertisement
5. Set-up
5.2 Flow of Set-up (Control Set-up Mode)
In order to perform the detailed control set-up, it is necessary to set-up Target Power Factor, Delay Time,
Capacity, etc. in Control Set-up Mode.
It changes from Operation Mode to Control Set-up Mode, and a required item has to be set-up.
The items you do not set up are the initial contents. (Please refer to the page 50 for the initial contents.)
Please refer to after page 30 for the setting details.
Operation Mode
Measurement
Display
SET CONT.
ENTER
*save the
settings
ENTER
*cancel the
setting
LOCK/RELEASE
Auto/Manual
Control Set-up
AUTO/MANUAL
Manual ON
AUTO/MANUAL
LOCK/RELEASE
Auto
AUTO/MANUAL
Manual OFF
Please refer to page 37
Control Set-up Menu END
＋
−
ENTER
DISPLAY
or
＋
−
It changes to the following item after deciding a set-up item.
Menu change.
Setting value moving down.
Menu change.
Setting value moving up.
It changes to a front item after deciding a setting value.
Setting value moving down. (fast forward)
Setting value moving up. (fast forward)
It locks or releases an automatic/manual change.
Control ( Manual ON / AUTO / Manual OFF ) of each
capacitor circuit is changed.
YES Display ： It changes to Operation Mode after
memorizing the contents of a setting.
CANCEL Display ： It changes to Operation Mode after
canceling the contents of a setting.
A YES display and a CANCEL displays are switched.
A YES display and a CANCEL displays are switched.
It locks or releases an automatic /manual change.
Control ( Manual ON / AUTO / Manual OFF ) of each
capacitor circuit is changed.
24
Control Set-up Menu 1
Control Set-up Menu 2
(Target Power Factor)
(Light Load Power Ratio)
＋
−
ENTER
DISPLAY
Target Power
Factor
ENTER
Motion
LOCK/RELEASE
AUTO/MANUAL
LOCK/RELEASE
AUTO/MANUAL
＋
−
ENTER
DISPLAY
Light Load
Power Ratio
ENTER
Key operation
press
ENTER
press
−
press
＋
press
DISPLAY
Press for
−
1 second
Press for
＋
1 second
Press for
2 seconds
press
press
ENTER
press
＋
press
−
Press for
2 seconds
press
Advertisement
Table of Contents
