Heta SCAN-LINE SOLID C Operating And Installation Instructions page 2

__________________________________________________________________________________________________________________________________
1. Unique identification code of product-type
2. Product name
3. Intended use or uses of the construction product, in
accordance with the applicable technical specification
4. Name and contact address of the manufacturer
5. Where applicable, name and contact address of
authorized representative. E-mail.
6. System of assessment and verification of constancy of
performance of the construction product
7. Notified body relevant to the assessment and
verification of constancy of performance
8. Declared Performance
Harmonized technical specification
Emission
9. Fire safety
Reaction to fire
Test of fire safety in connection with the burning of wood
Distance to combustible materials
Rear
Distance to flamable materials with side windows
Distance to flamable materials - infornt of the stove
10. Safety
Mechanical resistance (to carry a chimney / flue)
Electrical safety
Surface temperature
Cleanability
11. Thermal output
Nominal heat output
Energy efficiency
Fluegas temperature at nominal heat output
Water heating output
Maximum water operating pressure
The performance of the product identified in points1 and 2 is in conformity with the declared performance in point 8. This
declaration of performance is issued under the sole responsibility of the manufacturer.
Signed on behalf the manufacturer of
____________________________________________________________________________________________________________________
In case of any change of the above-mentioned production type this Declaration of Performance becomes invalid.
2
Declaration of Performance EN
Regulation No. 305/2011
DOP-Scan-Line Solid C 2237-2017
16.11.2017
Heta A/S, Jupitervej 22, DK-7620 Lemvig, Tlf. +45 9663 0600, www.heta.dk
Stove
Scan-Line Solid C
Room heater burning solid fuel without hot water supply
Heta A/S, Jupitervej 22, DK-7620 Lemvig. heta@heta.dk
Factory Manager Martin Bach, E-mail: martin.bach@heta.dk
System 3
Teknologisk Institut, DK-8000 Aarhus
Notified body No. 1235 Rapport nr. 300-ELAB-2237-EN rev. 2
EN 13229:2001/A2:2004
CO
Nox
Dust
Dust (NS3058/3059)
OGC (CEN/TS 15883) 81 mgC/Nm
A1
Approved
Minimum distances in mm
0
550
1100
Not tested (NPD)
NA
Approved
No specification
8 kW
Ƞ 79%
o
T 312 C
NA
NA
Page 1 of 1
Certifikat 2237
3
0,085% / 1063 mg/Nm
109 mg/Nm 3
3
27 mg/Nm
2,15 g/kg
3
ved 13% O
2