Page 1
40-40h / 45-45h / 55-55h stove is exempt for use in smoke control areas when burning dry wood www.heta.dk Danish DesiGn . Danish QUality . Danish ProDUCtion...
____________________________________ Lemvig 18-08-2016. Lars Kirk HOD _________________________________________________________________________________________ In case of any change of the above-mentioned production type this Declaration of Performance becomes invalid . Heta A/S, Jupitervej 22, DK - 7620 Lemvig, Tlf.: +45 96630600, www.heta.dk Page 1 of 1...
Page 3
____________________________________ Lemvig 18-08-2016. Lars Kirk HOD _________________________________________________________________________________________ In case of any change of the above-mentioned production type this Declaration of Performance becomes invalid . Heta A/S, Jupitervej 22, DK - 7620 Lemvig, Tlf.: +45 96630600, www.heta.dk Page 1 of 1...
____________________________________ Lemvig 18-08-2016. Lars Kirk HOD _________________________________________________________________________________________ In case of any change of the above-mentioned production type this Declaration of Performance becomes invalid . Heta A/S, Jupitervej 22, DK - 7620 Lemvig, Tlf.: +45 96630600, www.heta.dk Page 1 of 1...
Congratulations on your new wood stove, we are confident that you will be more than satisfied with your new Heta stove. Especially if you follow the following advice and instructions. Inspire 40 wood stove is approved according to EN 13240, NS 3058 and 3059. These...
It is important that upon receipt check your Heta product completely and report any damage or defects to your dealer. The packaging must be disposed of as follows: Wood is untreated and able to burn in the stove.
Page 7
Ash pan handle Heta glove 1020-0001 Data plate 2 x M8x25 0008-0206 8150-0000-DK 2 x M6x30 0008-1118 DOP-Inspire 40 Indsats-2215-2016 Heta A/S Jupitervej 22 7620 Lemvig Denmark Produktions år: 2016 2 x Washer 0008-0501 DS/EN 13229/A2:2004/NS 3058/3059 Produkt beskrivelse Serie nr:...
(after about ten minutes) closed door 1.2 first firing and regulate the air into operating position. We Heta wood stoves are, treated with a heat-resi- recommend, all of the first fuel is burned with stant coating, which hardens at a temperature the combustion air fully open in the operating of about 250°...
may be necessary to use the start-up air and the ashtray, see Fig. 6. It is advantageous to possibly have the door ajar. leave a layer of ash in the bottom of the combu- stion chamber on top of the grate as insulation. The wood will then ignite within a very short time For emptying the ash pan - use the supplied (Typically 1 to 3 minutes).
Good draft will allow the stove to achieve op- reduced draft can occur when: timal combustion and the highest possible ef- ficiency. Heta wood stoves are constructed so • The temperature difference is too small that it itself provides an optimal blend of com- between smoke gasses and outdoor bustion air.
chimney. Similarly, you must not fire your stove heating oil contains about 10 kW / hour. with refuse, painted wood, pressure-impregna- release ted wood or chipboard, as these materials can emit poisonous fumes and smoke. At combustion 1000 litres of heating oil forms 3.171 tons CO .
1.13 troubleshooting table Fault Cause Troubleshooting Solution Inadequate chimney draft. You can test using a lighter whether Improve the chimney. Lighting problems. When the The chimney only has stove is cold, smoke seeps flame is drawn into the combustion sufficient draft when it is hot. into the room.
1.14 Maintenance 1.15 Cleaning the glass Incorrect firing, for example using wet wood, The surface of the stove is treated with a heat- can result in the viewing window becoming resistant paint. The stove should be cleaned covered in soot. This soot can be easily and with a damp cloth.
1.17 Cleaning after sweeping or before replacing vermiculite stones Note: it may be necessary to clean/vaccum the holes and air ducts behind the rear stone Order of removing Fire bricks. Inspire 55-55H Inspire 40-40H + 45-45H Replace in reverse order. Starting with Fig. 6.
The nominal output is the output to which the stove has been tested. The test was carried out with the combustion air 65%. 1.21 Guarantee Heta wood stoves, subjected to a strict quality Should you have cause to make a complaint, control during production and before delivery to please quote our invoice no.
We recommend that you let a professional Heta dealer install the stove. Alter- In front of the fireplace insert, the substrate natively, you can ask the local chimney sweep must consist of non-combustible material, for before installation.
/ or 2010) especially when installing in newer build beading. Heta A/S stresses that it is of utmost properties when the stove is not going to be in- importance that this is done correctly with very stalled to an outside air supply.
2.6 Clearances for installation en 13 240 - inspire 40-45-55 Not combustible material Combustible material - Insulated flue Min. The dimensions are the minimum dimensions, unless otherwise stated. Snit A-A Snit B-B Clearances Srove Distance to flamable materials Minimum dimensions i rear the at the door bot-...
2.7 Clearances for installation en 13 240 - inspire 40h-45h-55h Not combustible material Combustible material - Insulated flue Min. The dimensions are the minimum dimensions, unless otherwise stated. Snit A-A Snit B-B Clearances Stove Distance to flamable materials Minimum rear the...
3. Data Plate Inspire 40-40H Inspire 45-45H Note your own number here 8050-0000-EN 8052-0000-EN DOP-Inspire 40 -1858-2016 DOP-Inspire 40 -1987-2016 Heta A/S Jupitervej 22 Heta A/S Jupitervej 22 7620 Lemvig Denmark 7620 Lemvig Denmark 2013 Production år: 2013 Production år:...
Page 27
4. appendix a The Clean Air Act 1993 and Smoke Control Northern Ireland. Therefore it is a requirement Areas Under the Clean Air Act local authorities that fuels burnt or obtained for use in smoke may declare the whole or part of the district of control areas have been ”authorised”...
Need help?
Do you have a question about the Inspire 40H and is the answer not in the manual?
Questions and answers