Reduced Burning; Risk Of Explosion; Emptying The Ash - Heta SCAN-LINE SOLID C Operating And Installation Instructions

Hide thumbs Also See for SCAN-LINE SOLID C:
Table of Contents

Advertisement

4
The wood will then ignite within a very short time
(Typically 1 to 3 minutes). Once the fuel is Ignited.
Close the door and regulate the air back to ope-
rating air. When the fire is well established, you
can now regulate the operating air to the desired
combustion level.
Nominal heat out-put is 8 KW, equivalent to the
operating air at about 40% open, requiring re
fueling after approximately 50 min.
Ensure when refueling that the wood is not too
close, it will cause poorer combustion, less heat
out-put and lower efficiency.
5
Vermiculite
(stone)
The fuel load, must be maintained below the top
series of air holes and within the outer vent in
each side. Fig. 5
When refueling be careful to place
the fuel into the combustion cham-
ber gently, (use the provided glo-
ve). By not doing so you risk crack-
ing or breaking the vermiculite.
If there is reduced draft in the chimney, we re-
commend opening a window at stoking. This will
give better ventilation to the room and more oxy-
gen for combustion.

1.6 Reduced burning

The stove is, designed for intermittent use.
It is important to maintain the layer of hot em-
bers. Lower heat out-put occurs when no flames
8
come from the tree, when it is becomes glowing
charcoal.
If you are looking for less heat out-put, achieve
this by fueling with smaller volumes of wood and
a lower operating air. You may not completely
close the operating air during firing.
Be aware that the stove will naturally soot if the
operating air is too low. This is not good for the
environment. There is also a risk for the glass,
the chimney and other parts will become sooted.
By a combination of the above and possibly
burning damp wood. Can lead to high levels of
soot that it becomes sticky. Causing the sealing
of the door to tear off when opening the door
the next day.
1.7 Explosion!!!
Explosion can occur if filled with too much fuel
in the stove, the production of large volumes
of gas, which can explode if the air supply be-
comes too low.
Maximum
wood filling
1.8
Be careful not to damage the vermiculite when
the removing the ash.
It is an advantage for the next firing to leave a
layer of ash lying in the bottom of the firebox.
Warning!
Children should avoid contact with the stove.
Setting up a fence if you have small children may
be necessary.
Do not place flammable objects like drying racks,
furniture, curtains too close to the stove.
It is very important never to leave
The stove after start up or refueling,
before the fire is established.
(Typically 1 to 3 minutes)

Emptying the ash

Be careful when emptying the
ashes out. There can be hot embers
left for a long time.
One must always use cation around
the stove seen, as it gets very warm
during use. (In excess of 90° C).

Advertisement

Table of Contents
loading

Table of Contents