Advertisement

Quick Links

OPERATING AND INSTALLATION
INSTRUCTIONS
SCAN-LINE
10/20/30 20B/30B
www.heta.dk
EN
DANISH DESIGN . DANISH QUALITY . DANISH PRODUCTION
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SCAN-LINE 10 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Heta SCAN-LINE 10

  • Page 1 OPERATING AND INSTALLATION INSTRUCTIONS SCAN-LINE 10/20/30 20B/30B www.heta.dk DANISH DESIGN . DANISH QUALITY . DANISH PRODUCTION...
  • Page 2: Safety Clearances

    Heta stove. Especially if you follow the following advice and instructions. Scan-Line 10/20/30 20B/30B have been approved according to the EN 13240, NS 3058, NS 3059 and A15 Austria. These approvals, means that the wood stove meets a variety of specifications and requirements, ensuring it is made of quality materials, minimum environmental impact and that it has an optimum fuel economy.
  • Page 3: Draft Conditions

    got so that any soot and condensation drops - The wind is blowing strongly. into the stove itself rather than collecting on the - The chimney is of the correct height: at exterior surface of the stove. For connections to least 4.00 m above the stove and free of the chimneys that are run through ceilings, all natio- roof ridge.
  • Page 4 Chimney fires poor combustion and insufficient exploitation of the fuel. In the event of a chimney fire – which often re- sults from incorrect operation or protracted fi- Reduced burning ring with moist wood – close the door and shut The stove is well-suited to intermittent use.
  • Page 5: Operational Problems

    Stove data table in accordance with EN 13240 testing. Stove type Nominel Smoke- Fuel Draught Nominal Actual Distance to flammable materials Distance to Stove fluegas stub volume output in mm furnitures weight efficiency temperatur tested from the Scan-Line behind at the Corner align- c°...
  • Page 6: Maintenance

    Guarantee - Damage caused by improper use. Heta wood stoves, subjected to a strict quality - Transportation costs for warranty repair. control during production and before delivery to - Assembly / disassembly of warranty repair.
  • Page 7 Important The cuts in the rings must be placed as shown in illustration to the right.
  • Page 8                                                                                                                                                                               ...
  • Page 9                                                                            ...
  • Page 10                                                                                                                                                                                                    ...
  • Page 11        ...
  • Page 12                  ...
  • Page 14          ...
  • Page 16                                                                                           Heta A/S Jupitervej 22, DK-7620 Lemvig Copyright © 2014 Printed in Denmark Heta is a registered Phone: +45 9663 0600 Subject to printing errors 02.09.2019 trademark of Heta A/S and changes. 0037-1196 Version 1,2 E-mail: heta@heta.dk...

This manual is also suitable for:

Scan-line 20Scan-line 30Scan-line 20bScan-line 30bScan-line 10

Table of Contents