Honda BF35A Service Manual page 379

BF40AoBF50A
d. INSTALLATION
Install the long tiller handle assembly to the motor.
Install the 10 mm washers and tighten the 10 mm
self-locking nuts to the specified torque.
TORQUE: 34 Nom (3.5 kgfom, 25 Ibfoft)
Pass the long tiller handle wire harness through the
under case grommet, and secure it with the wire har-
ness clamp.
Set the control cable setting plate into the groove of
the under case.
Pass the control cables through the under case grom-
met and set the control cables by aligning the groove
of the control cable with the cutout of the control
cable setting plate.
Adjust the control cables (throttle control cable length:
P. 3-6, shift control cable length: P. 3-8).
Connect the control cables to the shift arm and throt-
tle arm with the 6 mm plain washers and 6 mm lock
pins
[2] SHIFT CABLE
/
P I
WIRE HARNESS [5] WIRE HARNESS
CLAMP
r91 [61
THROTTLE CABLE SHIFT CABLE
[7] 6 mm
6 mm LOCK PIN (2)
WASHER (4)
15-22