Honda BF35A Service Manual page 424

1) Apply grease to the oil seal lip.
Check the oil seal lip.lf the oil seal lip is damaged,
replace the front bracket as assembly.
2) Expand the brushes and install the armature taking
care not to damage the oil seal.
Remove the burrs at the armature shaft with a fine
emery paper before assembly.
Make sure that the brush springs are in place
3) Apply grease to a new motor O-ring and install it on
the front bracket.
4) Make sure there is no metallic part (e.g. washer, etc.)
on the magnets before installation.
5) Apply grease to the yoke side end of the armature
shaft. Hold the armature shaft and install the yoke.
6) Tighten the three 5 x 20 mm screws to the specified
torque.
TORQUE: 2.2 N*m (0.22 kgfom, 1.6 Ibfoft)
7) After assembly, lightly tap on the outer surface of the
yoke with a plastic hammer (for snug fitting of the
armature bearing).
A
[ l ] ARMATURE
PI
BRUSH
I I
SPRING
151
FRONT
BRACKET
USHES
[4] O I L SEAL LIP
[ l ] 5 x 20 mm SCREW (3)
,[2]YOKE
[3] MOTOR O-RING
-
pGGGJ
13-25