BF40AoBF50A
11) Lift the left stern bracket and remove the gas assisted
damper.
Make sure that the tilt lever is in "RUN" position
before removal.
Store the gas assisted damper with fully extended
position
12) Remove the 26 mm wave washer and 10 mm dis-
tance collar.
13) Remove the lower cylinder bushings if necessary.
Replace with new ones when the lower cylinder
busing is removed.
*TILT LEVER REPLACEMENT
Before removing the tilt lever, set the tilt lever in the
"RUN" position
Install the tilt lever by aligning the mounting hole of the
lever with the tilt lever shaft and noting the installation
direction as shown.
1 1
1
10
mm
DISTANCE
COLLAR
[2] GAS ASSISTED
'
\
DAMPER
LOWER CYLINDER
BUSHING (2)
[3] 26 mm WAVE
WASHER
141
p x E i q
1
[41
/
TILT LEVER
\
[31
6
mm
SELF-LOCKING NUT
1
12 N*m (1.2 kgf*m, 9 Ibf*ft)
1
13-2