Honda BF35A Service Manual page 371

BF40AoBF50A
POWER TRIWILT SWITCH
Power trim/tilt type only: Install the power tilt switch so
that the "UP" mark is at the bracket bolt installation
hole side (lower side) as shown, and install the switch
grommet noting the direction.
Power trimhilt type only: Replace the wire band with a
new one, if it has been cut. After securing the wires
with a new wire band, cut the end of the wire band so
the projected end length is 10
-
20 mm (0.4
-
0.8 in).
Tighten the 5 x 10 mm hex. bolt to the specified torque.
Torque: 4.5 N*m (0.45 kgf*m,
3.3 Ibfuft)
[2] POWER T R I W I L T
131
SWITCH GROMMET
\
/
[4] "UP" MARK
Power trim/tilt type only: Check whether the power tilt
switch wire does not interfere with the 5 x 8 mm hex
bolt head.
131
*1
5
x 10 mm SCREW (2)
1 1 01
5 mm WASHER
- &
SWITCH BRACKET
POWER TRlM/TlLT
SWITCH
SWITCH HOLE GROMMET
161 *1
SWITCH GROMMET
171
*1: Power Trim/Tilt Type
*2: Gas assisted Tilt Type
15-1
4