9) Prepare a piece of piano wire of 1.5 mm in diameter
as shown.
7) Set the prepared wire in the holes in both sides of the
sleeve as shown, and secure the wire by inserting the
10
mm bolt into the sleeve. Remove the sleeve from
the valve body by pulling the wire with care not to
damage the valve body.
Remove the O-ring from the sleeve and discard it.
Replace the O-ring with a new one during reassembly.
8) Set the valve body as shown. Apply small squirt of air
pressure to the manual valve installation hole to
remove the valve B. Remove the valve B from the
valve body.
Remove the O-ring from the valve B. Replace the 0-
ring with a new one during reassembly.
[l]
About
50
m m
( 1
.O
in)
i.--------------i
3
-
4 m m (0.12
-
0.15
in)
I
[2]
PIANO WIRE
[3] 10
m m
BOLT
[4]
SLEEVE
[5] O-RING
Do not reuse.
[l]
O-RING
[2]
VALVE B
[2]
VALVE B
13-1 0