Honda BF35A Service Manual page 427

BF40AoBFSOA
9) Hold the power trimhilt assembly upright and bring the
oil
level to the lower edge of the oil filler port. Loosely
tighten the oil hole cap.
10)Move the piston rod from the fully compressed posi-
tion to the fully extended position two or three times
by operating the power trimhilt switch.
11)Push the "UP" side of the power trim/tilt switch again
to extend the piston rod fully.
12) Remove the oil cap bolt and check the oil level. If the
level is low, add ATF with a syringe or equivalent tool
until ATF flows out of the oil filler port.
13) Install the new O-ring on the oil cap and tighten the oil
cap to the specified torque.
TORQUE: 0.8 N*m (0.08 kgfom, 0.58 Ibf*ft)
14) Wipe up ATF spilled from the cylinder comp. thor-
oughly. Operate the power trimhilt switch and check
that the piston rod moves smoothly.
15) Check the blow pressure (P. 13-29).
e. UPPER JOINT METAL INSTALLATION
1) Apply LOCTITEa 271 or equivalent to the thread of
2)
Install the upper joint metal against the piston rod.
3) Holding the piston rod and tighten the upper joint
the piston rod.
metal to the specified torque.
TORQUE: 44 N*m (4.5 kgf*m, 33 Ibfaft)
11
3IL FILLER
'OLE
\
i t
Ib
121
OIL LEVEL
(LOWER EDGE OF
OIL FILLER HOLE)
[31
O-RING
[4] OIL HOLE CAP
0.8 N-m (0.08 kgfom, 0.58 Ibfoft)
[l] UPPER JOINT METAL
13-28