Ch-hi
The audible signal sounds
when the target number of
pieces is higher than the
preset tolerance range
Limit determination:
In the application menu, display the <check> menu item and confirm, pressing
TARE.
The <limit> symbol will be displayed. Confirm with TARE; the <limupp>
symbol will be displayed.
Confirm with TARE; wait until the window for value entry in the numerical form is
displayed where you can enter the upper limit value <limupp>.
limit value of the target number of pieces (for introducing the numerical value see chap-
3.2.2
) and confirm, pressing TARE. The <limupp> symbol will be dis-
ter
)
played.
Confirm with TARE; wait until the window for value entry in the numerical form is
displayed where you can enter the lower limit value < limlow >.
limit value of the target number of pieces (for introducing the numerical value see chapter
3.2.2
) and confirm with TARE.
Tolerance check start:
Determine the mean weight of an individual part, see chapter 9
Place the weighed material and, based on the tolerance symbols / audible signal,
check if the weighed material belongs to the preset tolerance range.
Weighed material
below
the preset tolerance
20
off
Slow beep
Standard
beep
Fast beep
Cont. beep
The < limlow > symbol will be displayed.
Weighed material
in the preset tolerance
The audible signal is off
Slow
Standard
Fast
Continuous
Enter the upper
Enter the lower
.
Weighed material
above
the preset tolerance
CKE-BA-e-2031