Alternating Trigger - UNI-T UTD2000 Series User Manual

NTSC
All line
Lines
Sync
Odd field
Even field
Line numbers
Previous
Figure 4-1 is an example screen display when PAL video trigger model is selected as
standard and the synchronization mode is selected as line synchronization. Figure 4-2 is
an example screen display when the synchronization mode is set to field synchronization.

4.5 Alternating trigger

During alternating trigger, the trigger signal comes from two vertical channels. Alternating
trigger is useful for observing two signals with different frequency. See the figure below for
display of triggered alternating waveform example and Table 4-7 and 4-8 for triggered
alternating menu setting.
Applicable NTSC video signal.
Set the video line to synchronous triggering.
Set the video to sync and trigger on specific lines, adjust through the multifunctional
knob on front panel.
Set the video to sync and trigger on odd field.
Set the video to sync and trigger on even field.
Adjust through the multifunctional knob on front panel.
Go to previous page.
Figure 4-1 Video Trigger: Line Synchronization
Figure 4-2 Video Trigger: Field Synchronization
30
UTD2000 Series User Manual