Chapter V Acquire System - UNI-T UTD2000 Series User Manual

to view more pretrigger information, you could adjust the horizontal position of waveform
by rotating horizontal position. By observing pretrigger data, you can view the waveform
before triggering. For example, the glitch can be captured at the moment of starting the
circuit, you can find out the cause of glitch by observing and anlyze the pretrigger data.
Chapter V
As shown in the figure below, the ACQUIRE on the control area is the function button
of Acquire System.
Press ACQUIRE button to enter data acquisition setting menu, set the data acquisition
mode through menu control button.
Function Menu Setting
Sampling
Peak value
Acquisition
Mode
High
resolution
Average
Averages 2~256
Real-time
Sampling
Equivalence
ON
Fast Acq
OFF
By changing the acquisition setting of the DSO, user can observe the wave change.
Assuming that the noise in signal is strong, non-average acquisition method and average
acquisition of 8 numbers are shown in the figure below:
.
Acquire System
Figure 5-1 Function Key of Acquire System
Table 5-1 Acquire Function Menu
Description
The DSO acquires data and reconstruct the waveform in the same time interval.
Set to peak value acquisition mode. The DSO finds the maximum and minimum
value of input signal in each acquiring interval and uses these values to display
waveform.
The DSO averages the proximal point of acquired waveform to reduce random
noise of input signal and display a smoother wave on the screen.
The DSO acquires some waveforms and calculate their average values, and
then display the final waveform.
Set average number by using the multipurpose knob, the average number is set
to 2, 4, 8, 16, 32, 64,128, 256, 512
Set to Real-time sampling.
Set to Equivalent sampling.
Acquire data in a way of high screen refresh rate to better reflect the dynamic
effect of waveform.
Turn off fast acquiring.
34
UTD2000 Series User Manual