Table of Contents
Advertisement
UNI-T
®
Uni-Trend Group Limited
Chapter Four: System Prompts and Troubleshooting
System Prompts
Time out prompt: Check the serial configuration or check whether the equipment is
properly connected.
Time out prompt: Check the USB configuration or check whether the equipment is
properly connected.
SCAN prompt: SCAN will perform single transmission. Please carry out single
refresh. Continue?
Are you sure you want to exit Virtual Instrument? A prompt will ask you if you wish
to close the software.
Troubleshooting
1.
If the system prompts you to check serial or USB configuration when you enter
[Equipment ON/OFF], take the following steps:
1
Check whether the oscilloscope power plug is properly connected.
2
Check whether oscilloscope ports match the testing and control software setups
(Factory default: RS-232 baud rate 4800).
3
Check whether the cable connection between module and PC is in order.
4
After carrying out the above checks, restart the software to continue operation.
. All right reserved 2007
___________________________________________________________________________________________
User Manual for UT2000_3000 Series Computer Testing & Control Software
28
Hide quick links:
Advertisement
Table of Contents
