Movement Alarm; Over Speed Alarm - GPS Tracker 403 User Manual

Note: The first latitude & longitude is coordinate of the top left corner of the
Geo-fence, and the second latitude & longitude is the coordinate of the
bottom right corner.
To configure the Geo-fence the tracker must fix to satellites and be
stationery for about 3-10 minutes.

6.16.6 Movement alarm

The movement feature will create a circle area with a set radius (200 meters by
default). When the tracker moves out of this area, SMS notification
"move!+latitude & longtitude" will be sent to the authorized numbers.
SMS command to activate: move+password+space+radius value
Tracker response: move ok!
Example: move123456 0200
SMS command to deactivate: nomove+password
Tracker response: nomove ok
Example: nomove123456
Note: The unit of the radius value is meter, and the value must be 4 digits and
maximum 9999 meters.
To configure the movement alarm, the tracker must fix to satellites and be
stationery for about 3-10 minutes.

6.16.7 Over speed alarm

The tracker can be configured to send an alert "speed+xxx!+latitude & longitude"
to authorized numbers when a certain speed in exceeded. In SMS mode, tracker
only sends one alert in 3 minutes, and siren beep for one second for each trigger.
SMS command to activate: speed+password+space+speed value
Tracker response: speed ok!
Example: speed123456 080
SMS command to deactivate: nospeed+password
Tracker response: nospeed ok
Example: nospeed123456
Note: The recommended speed should not be less than 30km/h. If the speed is
set lower than this you may get a false alarm due to GPS inaccuracy.
26