Installing The Array1000Udma Driver For Novell Netware; Installing The Driver When Installing Netware - Adaptec AAA-UDMA Install Manual

Adaptec aaa-udma raid controllers: install guide

Hide thumbs Also See for AAA-UDMA:

Table of Contents

AAA-UDMA Installation and Hardware Guide

Installing the Array1000UDMA Driver for Novell

NetWare

To begin driver installation, see either Installing the Driver When

Installing NetWare on page 6-2, or Installing the Driver When NetWare

is Already Installed on page 6-6.

Note:

We recommend that you install your Novell NetWare

operating system on a fault-tolerant array (RAID 1, 0/1, or

5) to take advantage of the redundancy and performance

features of the array.

To install the cdaudmah.ham driver when you are installing

NetWare, follow the instructions below for the version of NetWare

you are installing.

NetWare 4.11

Follow these instructions only if you are installing NetWare 4.11 for

the first time:

Create a DOS partition and install DOS on your system.

Edit the autoexec.bat file to include a command line for

mscdex.exe (the mscdex.exe file is included with MS-DOS 6.x

and above). The following sample command lines for the

autoexec.bat file are appropriate for most systems:

c:\dos\mscdex.exe /M:12

(This assigns the CD-ROM the next available drive letter, typi-

cally D if there is only one DOS drive.)

Reboot the system to the DOS partition.

Insert the NetWare CD in your CD-ROM drive.

Go to the CD-ROM drive.

Type Install and press Enter.

Follow the procedures in your NetWare documentation for

installing a new server.

6-2

Table of Contents