Table of Contents
Advertisement
Starting the BIOSSelect Utility
To start BIOSSelect, press the F6 key when the following prompt
appears when you turn on or reboot your system:
Press <F6> for BIOSSelect Utility!
The menu that appears displays the options Configure/View Host
Adapter Settings and Disk Utilities, as shown in Figure A-1.
Adaptec Array1000 Family
Adaptec Array1000 Family at Bus:Channel 00:A
Would you like to configure the PCI device, or run the
disk utilities? Select the option and press <Enter>.
Press <F5> to switch between color and monochrome modes.
Configure/View Host Adapter Settings
Arrow keys to move cursor, <Enter> to select option, <Esc> to exit ( * =default)
Figure A-1. BIOSSelect Menu
Using BIOSSelect Menus
To select a BIOSSelect menu option, move the cursor to the option
with the
and
keys, then press Enter. In some cases, selecting an
option displays another menu. You can return to the previous menu
at any time by pressing Esc.
To restore the original BIOSSelect default values, press F6 from the
Configure/View Host Adapter Settings screen. To toggle the display
between color and monochrome modes, press F5 from the main
BIOSSelect screen (this feature does not work on some monitors).
Exiting BIOSSelect
To exit BIOSSelect, press Esc until a message prompts you to exit (if
you changed any host adapter settings, you are prompted to save
the changes before you exit). Select Yes to exit, then press any key to
reboot the system. Any changes you made in BIOSSelect take effect
after the system boots.
Using BIOSSelect and Disk Utilities
BIOSSelect Utility
Options
Disk Utilities
A-3
Advertisement
Table of Contents
