Replacing The Boards; Led Board - Ametek Dycor CG1100 Series User Manual

Replacing the Boards

LED Board

Removing the LED board
1. Disconnect the top (6-connector) ribbon cable. See Figure 7-7.
2. Disconnect the bottom (9-connector) cable. See Figure 7-7.
3. Using a Philips screwdriver, remove the four screws holding the LED
board onto the front of the unit.

NOTE
Figure 7-6. LED board and connector cable locations.
Replacing the LED board
1. Using a Philips screwdriver, attach the LED board to the inside front
cover of the unit using the four screws.

NOTE
2. Reconnect the bottom (9-connector) ribbon cable.
3. Reconnect the top (6-connector) ribbon cable.
The bottom right-hand screw may be difficult to get at. Use a short-
handled or right-angled screwdriver to facilitate removal.
6-Connector Cable 6-Connector Cable
9-Connector Cable 9-Connector Cable
The bottom right-hand screw may be difficult to get at. Use a short-
handled or right-angled screwdriver to facilitate removal.
LED Board LED Board
Service and Parts | 7-7