Wiring Checks; Wiring Problem; Analog Board Connections; Ribbon Connectors - Ametek Dycor CG1100 Series User Manual

Wiring Checks

6-2 | Dycor CG1100 Oxygen Analyzer

Wiring Problem

Make sure all wiring connections are terminated to the proper locations
and are seated properly. This includes ensuring that sets of wires are not
reversed, and that the cable is not damaged.

Analog Board Connections

Connection
TB2 - Pin 1
TB2 - Pin 2
TB3 - Pin1
TB3 - Pin 2
TB3 - Pin 3
TB7 - Pin 1
TB7 - Pin 2
TB7 - Pin 3
TB7 - Pin 4
TB7 - Pin 5
TB8 - Pin 6
TB8 - Pin 1
TB8 - Pin 2
Figure 6-1. Analog board connections on CG1102.

Ribbon Connectors

P4
P2
not used P3
P5
J1
J2
J4
Figure 6-2. Ribbon connectors on CG1102.
Connector Label
Vso Valve
Vso Valve
+24 Volts
+24 VRet
chassis gnD
+15 Volts
gnD
Vout
chassis gnD
n/c
n/c
n/c
n/c
Mcu Board to Rs-232 (chassis)
Mcu Board to Rs-485 (chassis)
Mcu Board to Remote cal Board (80533sE)
Mcu Board to J3 Pins 1-6 on 80532sE Board
Analog Board to i/o (chassis)
Analog Board to J3 Pins 7-15 on 80532sE Board
Analog Board to Brook Mass Flow Meter
Wire Connection
Vso Valve Lead
Vso Valve Lead
(no polarity)
Red
Black
green/Yellow
Brown
Yellow
green
Blue
--
--