ITech IT-M3600 Series User Manual page 98

4. Select different functions for setting. For detailed information about List file
Edit List files
1. In the List function setting interface, select Edit, and enter the List file editing
2. At first, select the number of file to be edited. At maximum of 10 List files can
3. Press [Enter] key for confirmation. Enter the List editing page.
4. Select "List Setup", and press [Enter] key for confirmation. Set the
5. Select "Edit Step= x/y", and press [Enter] key for confirmation. Select the
Run Recall
editing, recalling and running, please refer to the specific introduction below.
The running, recalling and editing of List function are mutual prerequi-
sites. When the system has no existed List file, it is necessary to edit List
file, recall List file, and finally run the recalled List file.
menu.
be edited in this instrument.
Edit List = 1/10
1:List Setup
2:Edit Step= 1/1
3:Insert Step= 1/1
4:Add Step= 1/1
5:Delete Step= 1/1
6:Delete All= 1/1
7:Copy File 1 To 1
attribute parameters of the List file in successive.
The setting method for each item is the same. Select one item, and press
[Enter] key for confirmation. When the item is under Edit state, rotate the
knob to select the configuration value or set the value. Taking the CV mode
as an example, the interface display is as follows. The displayed voltage and
current are different under different modes.
1:Mode= CV
2:End State= Last
3:Repeat= 01
number x of List step to be edited, press [Enter] key, and enter the Step
parameter editing page.
"x" means the number of step to be edited, and "y" means the total number
of steps of the List. The total numbers of steps vary automatically when the
number of editing steps increase or decrease.
•
If the existing List file is a new and empty file, display Edit Step= 1/1. The
user cannot select the number of step to be edited, and can only start
editing from step 1.
Copyright © Itech Electronic Co., Ltd.
Edit
Load Function
86