Load Function; Programming The Input; Select The Operation Mode (Mode) - ITech IT-M3600 Series User Manual

5

Load Function

This chapter describes the functions and features of the power system in Load
mode. Divided into the following sections:

♦ Programming the Input

♦ Advanced Function
♦ Protection Function
5.1 Programming the Input

5.1.1 Select the Operation Mode (Mode)

When the [Load] key is pressed on the front panel, the instrument is switched
to Load. There are eight modes of operation, such as CC, CV, CR, CP, CV+CC,
CV+CR, CC+CR, CC+CV+CP+CR and Battery Sim., the operation mode can
de divided to basic operation modes and complex operation modes according
to function types. Battery Sim. is battery test mode.
•
•
The procedures to select the operation mode are as follows.
1. Press [Shift]+[V-set](Config) to enter into configuration menu.
2. Rotate the knob and select 1:Mode=CC and press [Enter] to confirm.
3. Rotate the knob to switch Mode value.
4. Press [Esc] to exit.
Basic operation modes: CC (constant current), CV (constant voltage), CP (-
constant power), CR (constant resistance);
Complex operation modes: CV+CC, CV+CR, CC +CR, CV+CC+CP+CR;
1:Mode=CC
For example, select CV and press [Enter] to confirm, the instrument under
the CV mode.
At this time, the [V-set] key light will be lit. Press [V-set] key to set the input
voltage.
•
When select a single mode in Config menu such as CC/CV/CR/CP. The
[V-set]/[I-set]/[R-set]/[P-set] keys can switch the CV/CC/CR/CP mode.
For example, under CV mode, if you press [I-set] key, the present mode
switch to CC mode and set the input current value.
Copyright © Itech Electronic Co., Ltd.
Load Function
78