Advertisement
3. To remove the lens, with the screwdriver press the Lens Release button (shown below) and
rotate the lens counterclockwise by a quarter.
4. Remove the lens through the front of the projector.
5. If installing a non-ultra short throw lens in the projector:
a) Remove the new boresight adapter and install the original standard boresight adapter.
Repeat the steps in Replacing the boresight adapter (on page 4) in reverse order.
b) Install the non-ulra short throw lens.
c) From the on-screen display, select Configuration > Service.
d) Enter the Service password.
e) Click OK.
f)
Select UST Install > None.
Ultra Short Throw Lens Installation Instruction Sheet
020-102569-05 Rev. 1 (11-2019)
Copyright
2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Ultra short throw lens installation
16
Advertisement
