Advertisement
2. To turn on the projector, press the Power button.
Adjusting the boresight
The boresight adjustment range changes depending on the orientation of the projector.
When adjusting the boresight with the internal test pattern, only limited lens shift can be performed
and source input is not allowed.
1. Note the location of each the boresight screw before continuing with this procedure.
2. To display a test pattern to assist with adjusting boresight, press TEST.
Four internal test patterns are available.
3. To switch to the next test pattern, press TEST.
4. To exit the Test pattern menu, press Exit.
To access the boresight test pattern after pressing Exit from the popup window, go to the
Service menu.
•
For 700-GS, 850-GS, and 1075-GS, to enable the boresight adjustment mode, from the
on-screen display select Configuration > Service > UST Lens Install > Test Pattern 1
to 4.
•
For 630-GS and 635-GS, to enable the boresight adjustment mode, from the on-screen
display select Settings > Service > Lens Install > Pattern 1 to 4.
Ultra Short Throw Lens Installation Instruction Sheet
020-102569-05 Rev. 1 (11-2019)
Copyright
2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Ultra short throw lens installation
13
Advertisement
