Table of Contents
Advertisement
2.4
Installing a Hot-swappable SCSI Drive
The system supports up to eight hot-swappable drive trays.
Follow these steps to install a hot-swap SCSI drive:
1. Open the front panel door.
2. Use your finger to release the drive tray as shown below and then
pull it out.
System Housing
Remove all jumper
drive before installing it into the system. Also,
for Single-Ended (SE) SCSI drives, remove the
terminator jumper before connecting the SCSI
drive to the system.
jumper connectors and the terminator jumper,
please refer to your hard drive's instructions or
manual.
connectors on the SCSI
For the location of the
2-23
Advertisement
Chapters
Table of Contents
