Table of Contents
Advertisement
3.1.5
Installing a Hot-swappable SCSI Drive
The system supports three kinds of hot-swappable drive trays, one
with wide SCSI interface board and one with narrow SCSI interface
board. The third is the single connector architecture (SCA) type. The
installation steps for the wide and narrow SCSI drives are basically
the same except for connecting the wide SCSI drive ID cable.
Follow these steps to install a hot-swap SCSI drive:
1.
Open the lower front door.
2.
Push the drive tray switch to the Unlock/Power Off position.
Unlock/Power Off
Figure 3-13
Unlocking the Drive Tray Switch
System Configuration
3-13
Advertisement
Table of Contents
