Table of Contents
Advertisement
PCI IRQ Sharing
VGA Palette Snoop .............. [Disabled]
Reset Resource Assignments ..... [No]
= Move Highlight Bar,
PCI IRQ Setting
This parameter allows for
devices. If you use plug-and-play (PnP) devices, set this parameter
to
.
The system then automatically assigns IRQs to PnP
Auto
devices. If your PCI device is not PnP, you can manually assign the
interrupt for each device. Refer to your PCI card manual for more
information.
These parameters allow you to specify the appropriate interrupt for
each of the PCI devices. You can assign IRQ3, IRQ4, IRQ5, IRQ7,
IRQ9, IRQ10, IRQ11, IRQ12, IRQ14, or IRQ15 to the slots.
4-30
PnP/PCI System Configuration
............... [No]
or
Auto
When the PCI IRQ Setting is set to
IRQ setting fields become gray and non-
configurable.
PCI Slots
Make sure that the interrupt you assign to the
various PCI slots are not used by other devices
to avoid conflicts.
= Change Setting, F1 = Help
configuration of PCI
Manual
Auto
AcerAltos 21000 System Guide
Page 2/2
, all the
Advertisement
Chapters
Table of Contents
