Connector Panel Removal/Installation; Power Supply Panel Removal/Installation - Sony DVW-522 Maintenance Manual

2-2. Removal/Installation of Cabinet

2-2-3. Connector Panel Removal/Installation

1. Turn off the POWER.
2. Remove six screws indicated → at the top and bottom
on the connector panel.
Removal of Screws
3. Remove the connector panel so as not to stretch the
harness as shown in the figure.
Removal of the Connector Panel
4. Install the connector panel in the reverse order of steps
1 through 3.
2-4
Screw
(BVTT3x6)
Connector panel
Screws(BVTT3x6)
Screws
(BVTT3x6)
Connector panel
2-2-4. Power Supply Panel Removal/
Installation
1. Turn off the POWER.
2. Remove two screws, and open the power supply panel.
Screw(BVTT3x6)
Removal of the Power Supply Panel
3. Remove a screw and a spring washer which secure the
ground terminal, then disconnect connector (CN002)
on the AC-139 board, then remove the power supply
panel.
Spring
washer
Disconnecting the Connector
4. Install the power supply panel in the reverse order of
steps 1 through 3.
Screw(BVTT3x6)
Power supply panel
Connector(CN002)/
AC-139 board
Power supply panel
Screw(BVTT4x8)
Ground terminal