Table of Contents
Advertisement
2-3. Cassette Compartment Removal/
Installation
Removal
1. Press the EJECT button with the power on.
2. Turn off the POWER.
3. Remove the upper lid.
(Refer to Section 2-2-1. )
4. Remove the plate MD assembly.
(Refer to Section 2-2-2.)
5. Loosen two screws, and remove the cassette
compartment bracket assembly.
6. Disconnect the connector (CN930) on the CL-29
board.
B3x6
(with stopper)
Removal of the Bracket Assembly
Bracket assembly
Connector
(CN930)
2-3. Cassette Compartment Removal/Installation
7. Remove the four legs of the cassette compartment for
fixing the position by lifting the cassette compartment
slightly and straight with A portions (two portions)
held.
8. Remove the cassette compartment by sliding up it
raising up the rear part with the B portion held as
shown in the figure.
n
In this time, do not move the cassette compartment to
right and left and do not widen the right and left side
panels. If the right and left side panels are widened, a
gear position might be changed or some parts might be
removed.
Cassette compartment
Left side panel
Removal of the Cassette Compartment
9. When putting the removed cassette compartment
outside of the unit, make the four legs for fixing
position faced down.
(Because the flexible card wire might be get damaged
if the cassette lid is faced down.)
Right side panel
2-5
Advertisement
Table of Contents
