Table of Contents
Advertisement
STEP 2
1. A022: HEAD OFFSET LEVEL
2. Insert alignment tape ZR5-1/1P into this unit.
3. Set the "*" mark to Start auto adjust using a
search dial (JOG mode).
4. Press the SET button (or switch S300 on the SS board).
(If the unit has already entered the STILL mode, the
adjustment is initiated.)
5. The "Push PLAY button" message is displayed on the
monitor screen.
Press the PLAY button to initiate the adjustment.
6. After adjustment is completed, the "ADJUST
COMPLETE" message is displayed on the monitor
screen.
7. Press the MENU button (or switch S301 on the SS
board) to return to the DIGITAL DT ADJUST menu
screen.
STEP 3
1. Save adjustment data.
2. On the menu of maintenance mode, set as follows:
A023: NV-RAM CONTROL
3. Execute SAVE ALL ADJUST DATA.
6-6. Adjustment after SS-52 board replacement
DIGITAL DT ADJUST
A022:HEAD OFFSET LEVEL
MODE : PLAY
*No operation
Start auto adjust
(2) Insert alignment tape
(3) DIAL
(4) SET or S300
DIGITAL DT ADJUST
A022:HEAD OFFSET LEVEL
MODE : PLAY
No operation
*Start auto adjust
Push PLAY button
(5) PLAY
DIGITAL DT ADJUST
A022:HEAD OFFSET LEVEL
MODE : PLAY
No operation
*Start auto adjust
ADJUSTING......
During adjustment
DIGITAL DT ADJUST
A022:HEAD OFFSET LEVEL
MODE : PLAY
No operation
*Start auto adjust
ADJUST COMPLETE
Adjustment completed
(7) MENU or S301
*A023:NV-RAM CONTROL
6-13
Advertisement
Table of Contents
