Table of Contents
Advertisement
1-5. Rack Mounting
1-5. Rack Mounting
The unit can be mounted in a 19-inch standard rack.
It is recommended to use the following kit.
Rack Mount Kit: RMM-110 (optional accessory)
or
RACK-MOUNT SLIDES: MODEL 305
Notes for rack mounting
• When several VTRs are mounted in a rack, keep the
spaces between the each VTRs in the rack 1U or more. It
is recommended to install a fan for ventilation. Good air
circulation is essential to prevent internal heat build-up in
a rack (5°C to 40°C must be met for all units).
• Never remove an upper lid and bottom plate during rack
mounting.
• Be sure to secure the rack to the floor to avoid accidents
when a unit is pulled out.
• Connect long enough cables on the connector panel,
considering that the unit is pulled out.
1. Remove the five screws on right and left side panels.
2. Install the inner members of the slide rails to the right
and left side panels with the screws removed.
B4x6
Inner member
Installation of Inner Member
1-4
slide length 558.8 mm (22 inch)
(ACCURIDE)
Inner member
B4x6
3. Remove the four feet on the bottom plate.
If the unit is mounted in the rack with the feet attached,
they will contact the lower and the upper portions of the
rack and the unit cannot be pulled out from the rack.
4. Install the outer member brackets of the slide rails to
the rack. Adjust the distance from the edge of the slide
rail to the outside of the rack so that it meets the
specifications in the Fig. 1 or Fig. 2.
‹Fig. 1›
Rack
L-angle
50
+5
mm
–0
‹Fig. 2›
More than 7 mm(Spacer)
Rack
L-angle
Examples of Outer Members Installation
Nut plate
Bracket
Outer member
Bracket
Outer member
Advertisement
Table of Contents
