Recording - FLIR Quasar Gen III CP-6302 Series User Manual

Table of Contents

Configuration and Operation

Disk Cleanup Setting

Enable automatic recording cleanup by selecting Enable automatic disk cleanup. From the pull-down

menu, specify the minimum length of time over which to remove recordings. For example, remove

recordings over 10 days old. Enter the percent of disk capacity used in order to remove the oldest

recordings. Click SAVE when finished.

Recording List

Each video file stored on the NAS is listed in the Recording list. See

the recording mode in the Recording screen is set as Always (consecutive recording) and the NAS

recording is enabled by events triggered, the system immediately saves a recorded event on the network

disk once an event occurs. Then the camera will return to the regular recording mode after events

recording. See Figure:

Selected File

Remove – To remove a file, first select the file and then click REMOVE.

Sort – Click SORT to list the files in the Recording list in order of name and date.

Note:

The capital letters: R, N, A, (A0), M, (M0) followed by an underscore, appear at the beginning

of the file name. They denote the type of recording.

R - Regular (always or schedule)

N - Network failure

M - Motion, (M0 refers to the first motion window trigger)

A - Alarm (A0 refers to the first alarm trigger input).

Download – To open/download a video clip, first select the file and then click DOWNLOAD. The

selected file window pops up as shown below. Click the AVI file to play the video in the player or

download it to a specified location. See Figure:

5.3.5.3

Recording

The Recording screen is used to select a device and to set a schedule for recording clips. Up to 10

schedules can be set.

Quasar CP-6302 Range User Guide - Ver. 8 - January 31, 2021

Window.

Recording Screen

This document does not contain any export-controlled information.

Recording

for further details. When

Selected File

Window.

Table of Contents