Basic - FLIR Quasar Gen III CP-6302 Series User Manual

Configuration and Operation
5.3.3.1

Basic

The Basic screen is used to configure the camera's basic network settings.
It is possible to connect to the camera with either fixed or dynamic (DHCP) IP address. The camera also
provides PPPoE (Point-to-Point Protocol over Ethernet) support for users who connect to the network via
PPPoE.
The Basic screen is divided into three sections: General, Advanced and IPv6 Configuration.
General
Select one of the following options in the General area for configuring network settings:
·
Get IP address automatically
·
Use fixed IP address
·
User PPPoE
Get IP address automatically
If you select Get IP address automatically, you can use the DNA utility, which can be accessed from the
FLIR website - see Accessing Camera Information from the
server on the network. See the Using the DNA Utility to Search and Access the Camera section of the
Quasar Gen III CP-6302 Range Installation Manual.
Quasar CP-6302 Range User Guide - Ver. 8 - January 31, 2021
Network > Basic Screen
This document does not contain any export-controlled information.
Web, to obtain the IP address from a DHCP
24