FLIR Quasar Gen III CP-6302 Series User Manual page 39

Table of Contents

Configuration and Operation

Alarm Switch

Four alarms are available. For each alarm, the Administrator can select from the following options:

Select Off to disable an alarm.

Select On to enable an alarm (default setting).

Select By Schedule to set a schedule. Then click Please Select to select up to 10 schedules from

the drop-down list that opens. The selected schedules are displayed in the Please Select text

box. To set a schedule, open the

Click SAVE after configuring the settings.

Alarm Type

Select an alarm type (Normal close or Normal open) that corresponds to the alarm application. Normal

open is the default setting. Click SAVE after configuring the settings.

Alarm Output

Define the normal alarm output signal as Output high or Output low, according to the current alarm

application. The default setting is high. Click SAVE after configuring the settings.

Triggered Action

The Administrator can specify various alarm actions to take when an alarm is triggered. See the

Triggered Actions

section for a detailed description of the actions. The following options are available:

Enable alarm output

high) to enable alarm relay when a network failure is detected.

Enable alarm output

high) to enable alarm relay when a network failure is detected.

Send Message by FTP – The Administrator can select whether to send an alarm message by

FTP when an alarm is triggered.

Send message by E-Mail – The Administrator can select whether to send an alarm message by

e-mail when an alarm is triggered.

Upload Image by FTP – Selecting this option enables you to assign an FTP site and configure

various parameters.

Quasar CP-6302 Range User Guide - Ver. 8 - January 31, 2021

IO Screen

Schedule

tab.

– Check this box and select the predefined type of alarm output (low or

This document does not contain any export-controlled information.

Table of Contents