Table of Contents
Advertisement
Phone Setup
Step 8
Tap Connect.
Add the Phone to a Nonbroadcast Wi-Fi Network
Follow these steps to add your phone to a Wi-Fi network that is hidden or not broadcast.
Before you begin
You need the following information about the Wi-Fi network:
• Network name or Service Set Identifier (SSID)
• Network security mode (None, PSK, EAP-TLS, EAP-TTLS, or PEAP)
• PIN or passkey for the security mode, if you use one
Procedure
Step 1
Swipe up from the bottom of the phone's display to show the installed applications.
Step 2
Tap the Settings
Step 3
Select Network & internet > Wi-Fi.
Step 4
Tap Add Network.
Step 5
Enter the desired Wi-Fi Network name.
Step 6
Select the desired Security:
• For an open network, select None.
• For a PSK enabled Wi-Fi network, select WPA/WPA2- Personal and enter the enter the 8-63 ASCII or
• For an EAP enabled Wi-Fi network, select WPA/WPA2-Enterprise.
Step 7
For an EAP-TLS, EAP-TTLS, or PEAP network, select the network EAP method: PEAP, TLS, or TTLS.
Step 8
For a network with an EAP-TLS security mode, select the desired CA certificate and User certificate.
Check with your administrator for the certificate type to select and also arrange to install the certificates on
your phone.
Step 9
For a network with an EAP-TTLS or PEAP security mode, select the Phase 2 authentication method and
CA certificate option to use, and then enter the Identity and Password.
Step 10
Under Advanced options, set Hidden network to Yes.
You can also set the Proxy and IP settings as required.
Step 11
Tap Save.
app.
64 HEX Password.
Add the Phone to a Nonbroadcast Wi-Fi Network
Cisco Webex Wireless Phone 800 Series User Guide
39
Advertisement
Table of Contents
