Phone Configuration - Cisco Webex Wireless Phone 840 Manual

Phone Configuration

Caution
Use only the approved USB cable for the Webex Wireless Phone 840 and 860.
Procedure
Step 1 Plug the USB cable into the bottom of the phone with the pins aligned.
Step 2
Plug the USB cable into a USB port on a computer.
Related Topics
Phone Configuration
For your phone to work, it must connect to your organization's Wi-Fi network and call control system.
Phone configuration uses one of these methods:
• Your administrator sets up the phone—You don't need to do any manual configuration. Your administrator
• You set up the phone for your Wi-Fi network and connect to the call control system—Your administrator
Once your phone is connected to the Wi-Fi network and call control system, you may want to:
• Configure Cisco Phone
• Pair your Bluetooth
See Settings
Wi-Fi Profile Configuration
For an out of box or factory reset phone, you configure the Wi-Fi network through the startup wizard or select
Set up offline. How you configure the phone offline depends on whether the Wi-Fi network is either:
• Broadcasted
• Nonbroadcast or hidden
Phone Setup
8
Cisco Accessory Part Numbers
may even lock your access to the configuration menus.
gives you the information that you need to add your phone to the Wi-Fi network and call control system.
Note
If your organization's Wi-Fi network does not contain DHCP Option 150 to direct
your phone to the call control system, then you can manually point the phone to
the TFTP server for your call control system environment.
®
device to the phone.
for detailed directions.
app User settings, such as ringtones and automatic noise cancellation.
Phone Setup