Table of Contents
Advertisement
Phone Setup
Charge the Battery with the AC Power Supply
If you don't have a desktop charger or multicharger, you can charge your phone battery using the USB cable
and AC power adapter.
Any cables or adapters must be USB certified and built to the USB-C specification.
Procedure
Step 1
Plug the USB cable into the bottom of the phone with the pins aligned.
Step 2
Plug the USB cable into the power adapter.
Step 3
Plug the power adapter into the electrical outlet.
Charge the Battery with the USB Cable and a USB Port on Your Computer
If you don't have a desktop charger, multicharger, or USB and AC power adapter, you can charge your phone
with a USB cable and computer. However, this method takes more time to charge your phone than the other
methods.
Any cables or adapters must be USB certified and built to the USB-C specification.
Procedure
Step 1
Plug the USB cable into the bottom of the phone with the pins aligned.
Step 2
Plug the USB cable into a USB port on a computer.
Phone Configuration
For your phone to work, it must connect to your organization's Wi-Fi network and call control system.
Phone configuration uses one of these methods:
• Your administrator sets up the phone—You don't need to do any manual configuration. Your administrator
• You set up the phone for your Wi-Fi network and connect to the call control system—Your administrator
Once your phone is connected to the Wi-Fi network and call control system, you may want to:
may even lock your access to the configuration menus.
gives you the information that you need to add your phone to the Wi-Fi network and call control system.
Note
If your organization's Wi-Fi network does not contain DHCP Option 150 to direct
your phone to the call control system, then you can manually point the phone to
the TFTP server for your call control system environment.
Charge the Battery with the AC Power Supply
Cisco Webex Wireless Phone 800 Series User Guide
37
Advertisement
Table of Contents
