Wi-Fi Profile Configuration; Add The Phone To A Broadcasted Wi-Fi Network - Cisco Webex 800 Series User Manual

Wi-Fi Profile Configuration

• Configure Cisco Phone
• Pair your Bluetooth
See Settings
Wi-Fi Profile Configuration
For an out of box or factory reset phone, you configure the Wi-Fi network through the startup wizard or select
Set up offline. How you configure the phone offline depends on whether the Wi-Fi network is either:
• Broadcasted
• Nonbroadcast or hidden

Add the Phone to a Broadcasted Wi-Fi Network

You add the phone to a broadcasted Wi-Fi network through the startup wizard, or offline through the Settings
app.
Before you begin
You need the following information about the Wi-Fi network:
• Network name or Service Set Identifier (SSID)
• Network security mode (None, PSK, EAP-TLS, EAP-TTLS, or PEAP)
• PIN or passkey for the security mode, if you use one
Procedure
Step 1 Swipe up from the bottom of the phone's display to show the installed applications.
Step 2
Tap the Settings
Step 3 Select Network & internet > Wi-Fi.
Step 4 Tap the desired Wi-Fi network name.
If the network does not have a security mode, the phone automatically connects to the Wi-Fi network.
If the network security mode is PSK, enter the 8–63 ASCII or 64 Hex Passphrase.
Step 5
For an EAP-TLS, EAP-TTLS, or PEAP network, select the network EAP method: EAP-TLS, EAP-TTLS,
or PEAP.
Step 6
For a network with an EAP-TLS security mode, select the desired CA certificate and User certificate.
Check with your administrator for the certificate type to select and also arrange to install the certificates on
your phone.
Step 7 For a network with an EAP-TTLS or PEAP security mode, select the Phase 2 authentication method and
CA certificate option to use, and then enter the Identity and Password.
Cisco Webex Wireless Phone 800 Series User Guide
38
app User settings, such as ringtones and automatic noise cancellation.
®
device to the phone.
for detailed directions.
app.
Phone Setup