Rst Command; Table 5-1, Power-On And Reset State - Racal Instruments 1256 Manual

Publication No. 980855 Rev. A

*RST Command

Attribute
Relay States
Trigger Input Source
Trigger Count
Trigger Input Delay
Trigger Output
Trigger Output Delay
Confidence Mode
Pathname List
Scan List
Include List
Exclude List
EADS North America Test and Services
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
This reply indicates the manufacturer of the instrument is EADS
North America Test and Services, that it is a 1256 Switch System,
and the current firmware revision. The firmware revision is a
numeric, floating point value. An example firmware revision is
"3.10". A sample is shown below:
Racal Instruments 1256 Switch System,3.10
The *RST command resets the instrument to its power-on default
state. These settings are shown in Table 5-1 of this manual.
This command does NOT change the value of SCPI Operation or
Questionable status registers or IEEE-488.2 status registers,
condition registers, or enable registers. This command does NOT
clear the error message queue, the input command buffer, or the
output reply buffer.

Table 5-1, Power-On and Reset State

Related Command(s)
*RCL 0
OPEN
CLOSE
TRIGGER:SOURCE
TRIGGER:COUNT
TRIGGER:DELAY
OUTPUT:TRIG
OUTPUT:DELAY
MONITOR:STATE
ROUTE:PATH
ROUTE:SCAN
ROUTE:INCLUDE
ROUTE:EXCLUDE
1256 User Manual
Reset State
The states are recalled from non-volatile
memory location 0 (power-up state). As
shipped from the factory, these are all in the
OPEN position.
IMMediate
1
0.0 seconds
Off
0.0 seconds
Off
Pathnames stored in non-volatile memory
are automatically recalled at power-up.
No Scan List Defined
No Include Lists Defined
No Exclude Lists Defined
SCPI Command Basics 5-17