GAUI Hurricane 255 Operating Instructions Manual page 53

Electro helicopter
Hide thumbs Also See for Hurricane 255:
Table of Contents

Advertisement

Available languages

Available languages

3.
Adjusting values
• In the setting mode, you will now also hear different signals (see top line of the following table), which repeat in a
continuous loop. The point where the sequence starts again depends on the menu item set, since only those sounds
are emitted for which a value is set and stored as well.
• After the sound signal for the desired value, slide the throttle control lever from the bottom-most position (motor off)
to the full throttle position at once.
• 4 sounds are emitted as confirmation for the stored value.
• The speed controller returns to the programming mode, where you can call and set the next menu item if required.
Braking
Battery type
Cut-off mode
Cut-off switching threshold
Start mode
Timing
The standard settings are displayed on a grey background in the table.
4.
Leaving the programming mode
• If the controller is in programming mode, wait until menu item 8 is acoustically displayed. Then slide the throttle
control lever from the full throttle position to the bottom-most position (motor off) within 3 seconds of the sound
signal. Depending on cell number, 2 – 4 brief sounds are emitted, followed by a slightly longer sound. The controller
is now ready for operation.
• Once the controller is in setting mode and you have stored a new value, pull the throttle control lever back to the
bottom position(motor off) right after the confirmation sound sequence. Depending on cell number, 2 – 4 brief
sounds are emitted, followed by a slightly longer sound. The controller is now ready for operation.
Technical Data
Power supply .................................................. 2 – 4 LiPo-cells or 5 – 12 NiMH-cells
Continuous current ......................................... 22 A
Peak current ................................................... 25 A
BEC output power .......................................... 5 V/2 A
Dimensions .................................................... 45 x 24 x 11 mm
Weight ........................................................... 19 g
1 x brief
2 x brief
Off
On
Lithium
NiMH/NiCd
soft
hard
low
medium
normal
soft
low
medium
3 x brief
high
very soft
high
53

Advertisement

Table of Contents
loading

This manual is also suitable for:

209876

Table of Contents