Roland R1000 Series Manual page 81

B0046191 / Rev. 1.12
Binary scheme for the sensor selection:
Sensor selection B
0
0
1
1
The sensor selection A/B is active only if it is the version 4P and in the system configuration
"Sensor selection external" has been selected.
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Double Sheet Detector R1000 series E20
with integrated fieldbus interface
Sensor selection A
0
1
0
1
Attention The sensor selection A/B must take place, when no measurement
is active. The selection is taken over with the next measurement.
This also applies to the general zero adjust and Teach-In 1-sheet.
Note In the following timing diagrams all outputs and inputs via the bus
are designated as BOUT and BIN, in contrast, the opto coupler
interface uses OUT or IN.
Manual
Sensor
1
2
3
4
Communication with the PLC
81