Unpack The Device; Install The Ceiling Mounting Plate - Berbel Skyline BDL 95 SK Operating And Installation Instructions

Installation
☞ Assemble the tools and materials required:
y Stable stepladder
y Folding rule or measuring tape
y Pencil
y Spirit level
y Phillips screwdriver PH1, PH2
y ø 8 mm masonry bit
y Hammer drill
y 13 mm spanner
y Allen key SW 2.5 mm
y Protective material (e.g. thick cardboard) for the hob
and the worktops
☞ Keep the installation area free of objects that could be in
the way or that could be damaged.
☞ Make sure that the hob and other parts that could be
touched have cooled down.
☞ Protect the hob and other surfaces in the installation area
(e.g. with thick cardboard).
☞ Ensure that the power supply is switched off and remains
so. Connect the power supply only when instructed to do
so in the installation instructions.
3.5.2
3.5.3

Unpack the device

D ATTENTION!
Hazard of glass breaking or other damage due to
incorrect handling.
The device and its surfaces can be damaged when being
unpacked or transported.
☞ Do not cut into the protective cardboard packaging.
☞ Keep objects that could scratch the device far away from
it (e.g. tools, belt buckles).
☞ Unpack the device and all accompanying parts carefully.
☞ Set the device down on a firm, clean and protective
surface (e.g. thick cardboard).
☞ Check the device and its constituent parts for damage.
☞ Check the delivery is complete.
D "2.5 Scope of delivery" (page 68).
If parts are missing or damaged:
☞ Please consult your dealer or customer services.
☞ Remove the packaging material.
D "8.1 Dispose of packaging" (page 90).
72
3.5.4

Install the ceiling mounting plate

The device is designed to be hung on ceilings.
When mounting to a solid ceiling:
☞ Make sure that the ceiling has sufficient load bearing
capacity.
☞ Ensure that the ceiling is level and horizontal.
☞ Use the fastening materials provided.
With different installation situations:
☞ Enquire about alternative fastening systems (e.g. consult
with your architect).
☞ Only use fastening hardware suitable for the type of
ceiling.
When hanging, first attach the ceiling mounting plate to
the ceiling and then screw the hood body onto the ceiling
mounting plate.
=
a Gap between two
bolt anchors
b Gap between two
bolt anchors
c Diameter of circle
over slots
☞ Determine the hanging position. Observe the hob
position:
y The ceiling mounting plate's centre point is directly
above the hob's centre point.
y The ceiling mounting plate runs parallel to the hob.
a
=
721 1021 1183 1602
mm mm mm
270 200 200
mm mm mm
770 1040 1200 1625
mm mm mm
6002782_b – 14.09.2016
mm
270
mm
mm