Default Cal - KARL DEUTSCH LEPTOSKOP 2042 Instruction Manual

12.2.8 Default Cal

When to use?
Measurements on standard material (if in doubt please check the possible
measurement accuracy as described in section 13.2).
Selection for check of the measurement accuracy of the instrument (see
section 13.2).
How to proceed after initiation of menu topic "Default Cal":
Strike again. A safety request will appear: "Default Cal ok". Only if this
request is confirmed by striking
urement with underlying Default Cal. Use
set to Default Cal.
The accuracy of the default calibration depends on the proper condi-
tion of the probe tip. The probe tip is subject to tear and wear and is
affected by the conditions of measurement. Thus the built-in default
calibration should be checked in regular time intervals (see
section 13.2).
Instruction Manual LEPTOSKOP 2042
38
, the instrument will change to meas-
if you want to cancel the re-
Art. No. 7423.421