Table of Contents
Advertisement
8.2 Switching on/off
SWITCHING ON:
needs to be pressed briefly. Wait
for the beep.
When switching the gauge on a start measurement is executed, which
expects the probe to be lifted. Thus do not place the probe during
switch-on. Otherwise the error message Lift probe ! will be shown
accompanied by three short alarm beeps.
After first switch-on you may start measurement without prior calibra-
tion using the factory setup. Note the information in section 12.
8.3 Display
Depending on the operation mode the readings, evaluations and measure-
ment modes are displayed via various display modes.
In the following the screen contents of the display modes Standard, Statistics
and Analog Representation are explained in detail. Information on possible
additionally shown symbols and messages can be found in section 8.4.
The various display modes become automatically activated and are suitable
for the current operation mode. In addition, they can be selected in turn via
the arrow keys: Normal -> Statistics -> Analog -> Normal ->Statistics -> ...
etc.
Instruction Manual LEPTOSKOP 2042
SWITCHING OFF:
needs to be pressed for approx. 3 s .
Wait for the beep. The calibration will be
memorized.
Art. No. 7423.421
11
Hide quick links:
Advertisement
Table of Contents
