8.3.1
Standard representation
8.3.2
Statistics representation
8.3.3
Analog representation
Instruction Manual LEPTOSKOP 2042
12
(1) Probe type
(2)
Symbol, if printer output is active
(3) Reading (after switch-on and with illegal values
3 horizontal lines are shown at first, in all other cases
you will see the current reading)
(4) Battery capacity
(4 levels: empty
(5) Measuring indication
= idle in measuring mode "Single"
= idle in measuring mode "Continuous"
= measuring
(6) Measurement unit (µm, mm, mil or inch)
(7)
Warning notice: the instrument is subjected to an
interference field (see section 4): eliminate the inter-
ference field and repeat measurement!
(8)
Symbol is shown if no probe is connected
(1) Probe type
(2) Number of readings
(3) Current reading (after switch-on and with illegal val-
ues 3 horizontal lines are shown at first, in all other
cases you will see the current reading)
(4) Measuring indication (as in 8.3.1)
(5) Minimum value (bottom) and maximum value (top)
(6) Arithmetic mean
(7) Measurement unit (µm, mm, mil or inch)
(8) Standard deviation according to
(1) Measuring range
(2) Analog scale
(3) Measurement and indication unit
(4) Probe type
(5) Current reading (digital)
(6) Measuring indication (as in 8.3.1)
full)
Art. No. 7423.421