Additional Symbols And Abbreviations In The Display - KARL DEUTSCH LEPTOSKOP 2042 Instruction Manual

8.4 Additional symbols and abbreviations in the display

Instrument is subjected to an interference field, measurement is
not possible
Display of the entered limit values (maximum value top, mini-
mum value bottom)
Display of the entered offset value
The measured value lies outside the accepted measuring
OVL
range of the connected probe (remedy, if the estimated meas-
ured value lies within the valid measuring range and a false
measurement or false calibration can be assumed: repeat
measurement/calibration and/or reset gauge to factory settings,
see section 12.2.8)
Brief display indication on the initialisation of the interface
UART
Points to the fact that the indicated reading is one reading
within a sequence of readings and is used to determine the lo-
cal thickness (see section 10.2.1), the example shows "5th
reading out of 20".
The connected probe is detected as Fe probe
Fe
The connected probe is detected as NFe probe
NFe
Reading is above the upper limit (see 10.2.2)
Reading is below the lower limit (see 10.2.2)
The gauge has recognized a connection to a USB interface
Power supply comes from a connected mains unit.
If a measuring file is loaded: Information on the name of folder
(top) and file (bottom)
Instruction Manual LEPTOSKOP 2042 Art. No. 7423.421
13