KARL DEUTSCH LEPTOSKOP 2042 Instruction Manual page 21

10.2.2 Limits
Limits can be used to check whether the readings lie within a selectable
bandwidth. If limit monitoring is selected to ON excess of limits is indicated
acoustically and optically:
acoustically:
Off
On
Set limits
10.2.3 Offset
The offset value decreases or increase the measured value for a selectable
amount.
Off
On
Set Offset
Instruction Manual LEPTOSKOP 2042
Double tone instead of single tone during measurement
Symbol indication: > when exceeding the upper limit
Monitoring of limits is selected to OFF
Monitoring of limits is selected to ON
Setting the limits (sequence: minimum -> maximum):
Fig. 8: Graphical
indication of read-
ings
Fig. 9: Analog
display
Offset is selected to OFF
Offset is selected to ON
Setting the offsets
< when dropping below the lower
limit
With the graphical indication of
readings (see section 10.3) the
limits are shown as dotted lines.
With the analog display
(see 8.3.3) the limits can be used
as upper and lower scale end val-
ues.
Art. No. 7423.421
21